Adjustable router template by lukasglowinski

lukasglowinski

Tools>Other Tools

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.3mm layer, 2 walls, 5% infill

Designer

5.6 h

1 plate

4.7(3)

0.16mm layer, 3 walls, 15% infill

Designer

1.1 h

1 plate

4.5(2)

Looser tolerance inserts (-0.1mm width, -0.5mm stem, -0.15mm Z)

53 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

Adjustable router template. Easy to print, but it takes some time. If the size(limited by the print height of the X1C) is not enough you can print additional profiles and extend the length or width.

To put it together you will need heated inserts, 2 for connecting sliders and 2 for the profile if you want extend it.

For fastenners I advice M4 button head 18mm screw. You can use different type but then you will need use some washers as wel. Also they need to be operated with allen key. There is no space for screwdriver.

The round block is to support router. Fits on my Festool OF1010. You can use it when you unscrew one of the screws holding the router plate. Then you fix it with M4 button head 18mm. It may fit other routers as well as long as they have M4 hole at the bottom plate.

Comment & Rating (7)

@seiras_3d_art

Print Profile

0.3mm layer, 2 walls, 5% infill

amzing print

@Makanize

Print Profile

0.3mm layer, 2 walls, 5% infill

This is a useful tool to have. A bit stiff but still pretty good. May be better to put the chamfer on the other side of the pins as it's easier to install the inserts from the other side.

@iczerjones

Awesome model, thank you! Design is fantastic and it's already been put to good use in the shop. I had some issues getting the slides to fit without some sanding/modification, but that could have been due to the filament I was using or who knows what. Ended up modifying the slide dimensions slightly to maintain a tight but workable fit. Thanks again!

@Makanize

Print Profile

0.16mm layer, 3 walls, 15% infill