Palia Hot Pot game tiles - coloured

Patreon - https://patreon.com/CosmicNimbusPrinting
Cults3D - https://cults3d.com/en/users/CosmicNimbus

Hello !

I've been playing a game called “Palia” with my friends, and there's a fun mini-game that I couldn't help but recreate to print ! This is a version 2 of this game, which I've printed out in multicolour, and made a cool case for it too. I split the rack which has a lock/key with a small tolerance.

PRINT:

To play you need 4 copies of each tile and 4 players. There are 8 sets of 3 tiles, which is 96 tiles.

• 4x copies of each tile = 96 tiles
• 4x tile stands

EASY RULES:

Shuffle tiles face down in centre of table. Each person takes 8 tiles for their rack. Stack the remaining tiles in a square in the centre: 2 tiles high, 8 tiles long each side - like in the render image. Take 1 tile from the top stack of one corner and face up in the centre of the square.

The goal is to get 3 sets of 3 tiles - Each are either 3 of a kind, or all 3 of a set. All the sets are shown in the last image on the listing.

• 3 of a kind = 120 points
• All 3 of a set = 60 points

On each turn a player will either take the next tile from the wall (top then bottom, then the next in line), or one of the tiles on the far right of another players discard line. They will then choose a tile to discard and put it face up in their discard line (a line from left to right in front of their rack).

The game ends either when a player collects 3 sets, or the tiles in the centre run out (around 20 rounds). Everyone gets all the points for all matched sets at the table, the winner gets 360 bonus points !

COLOURS I USED:

I specifically bought some nice matte filaments for the tiles, but skimped in some places and printed with what I had for the rest haha Below are the Filaments I used for my print. I think you can really have fun with the colours, and really print them in any colour you like! Some nice silk filaments for the coloured parts would be nice I reckon ! Just make sure to optimize the print profile for it if you go this route

Tiles
- White: Polyterra Cotton White
- Blue: Polyterra Arctic Teal
- Green: Polyterra Forest Green
- Purple: Polyterra Lavender
- Orange: Generic PLA+ (Could use polyterra Sunrise orange)
- Yellow: Polyterra Banana
- Grey: Polyterra Fossil Grey
- Red: Polyterra Watermellon
- Brown: PolyTerra Pastel Peanut

Case & Rack
- Gold: Bambu Labs basic gold
- White: Polylite Silk White
- This was a wood PLA someone bought me, which I clear-coated, but would look good in Pastel Peanut or any brown imo!

NOTE: This is based on a minigame found in a game called Palia, owned by Singularity 6, I do not own it's IP, this is a fan recreation not for sale or monetary profit

Happy printing !