Articulated Chameleon Toy by zuperbuuworks

zuperbuuworks

Toys & Games>Other Toys & Games

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill

Designer

3 h

1 plate

4.5(20)

0.16mm layer, 2 walls, 15% infill

Designer

1.3 h

1 plate

4.4(7)

With Brim, easy to remove, 0.2mm layer, 2 walls, 10% infill

2.4 h

1 plate

Boost

111

231

241

Released

Description

This Chameleon is articulated with 21 joints. The body parts can move up, down, left, or right. Forearms move side-to-side, arms move in all directions, and hands can move up and down.

You can print it smaller, but for best results print it at the provided size. You can print it bigger for a greater range of movement, and at a higher quality to see all the details in the model better.

I print it without a brim in PLA just fine. So long as your hotbed is clean/freshly glued you shouldn't have any issues. Do not print it with supports; it does not need them, and can damage the model when you try removing it from the supports!

The range of movement can be seen in this video: https://youtu.be/wvX6i_opni8

This file covers PERSONAL printing use. If you would like to sell prints, please sign up for Tier 1 of my Patreon: https://www.patreon.com/thomastedwards

Comment & Rating (30)

@wishper

Print Profile

0.16mm layer, 2 walls, 15% infill

maybe it should be a little bit bigger, because the smallest parts were sticking together

@zuperbuuworks

pictures of the model in other colours.

@chaloupkanathan

Print Profile

0.16mm layer, 2 walls, 15% infill

Pront quality was great, some of the internal supports of the leg joints stuck and took a bit of work to cleanup.

The designer has replied

@zuperbuuworks

hi, to avoid issues, the model prints best without supports; even if BambuLab slicer says it has floating geometry and needs them. The overhangs print well with no supports because they're less than 40 degrees in angle.