Watkins Glen Track Map with Nameplate Wall Art
Copyright Claim
Watkins Glen Track Map with Nameplate Wall Art
Boost
12
16
15
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
12
16
15
1
76
47
Released
Description
3D MODEL DESCRIPTION
Track map wall art for racing enthusiasts! Models range from 180 -250mm wide but can be scaled or broken up for your needs. Use wall-safe double-sided tape for wall adhesion with mess/damage-free removal.
3D PRINTING SETTINGS
.20 layer height
15-20% infill
2-3 walls
Pause for filament change at nameplate start
Iron the top layer only for a clean smooth finish
Comment & Rating (15)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
father in law loved it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Nice one, but not manifold. Take a lot of time to repair.
2
Reply
The file has manifold errors that are hard to repair. It impact one's ability to quickly apply different colors.
The designer has replied
0
Reply
you don't need to fix these. just ignore and slice. The filament change is already built into the 3mf file. just slice and print.
0
Reply
Boosted
Just did 6h of the Glen on iracing and I printed this for the team- 4th place in lmp2 so think we deserved a trophy of sorts! Will be printing the next endurance race we do too. Boosted thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great model, easy to print
(Edited)0
Reply
Do you happen to have one for the NASCAR configuration? without the boot?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints perfect, can't wait to put them up on the wall
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great model, printed perfectly and very fast
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld