Hello

This is my first 3D design.
The idea came to me when I was annoyed by how many times I had to go back to my bosch drill crate/box to swap the drill bit.

This attachment's teeth goes into the holes that are on the bottom of the drill, near where the battery is. As shown in the picture.
You will also need a screw to hold it in place.

It's:
36.8mm wide
27mm tall

The fitment might be tight but it's like that by design so that the bits don't fly off when you holster your drill on a belt (on the other side of the drill there's this attachment that you can use to put your drill on the belt or pocket seam)

I hope you enjoy it.

This one I printed with PLA.
I'm thinking about printing it with flexible filament as well, so that the fitment of the bits is better, but I'm not sure how durable it will be in working conditions.