Tesla Coaster
Copyright Claim
Tesla Coaster
Boost
15
27
18
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
39 min
1 plate
Boost
15
27
18
1
55
48
Released
Description
Tesla coaster
Comment & Rating (18)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
alles gut
The designer has replied
0
Reply
Thx for printing
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
artifacts on rear of model cause small extrusions and causes some minor imperfections. not bad though
(Edited)The designer has replied
0
Reply
It’s the rear of the coaster, turn on ironing if you want the back nice, but it’s pointless,
Thx for the 3 stars
0
Reply
Replying to @SlowpoksWorksho
yes that's an option, however every other coaster has a flat back, it's an easy fix, easier to fix the model then tell everyone to turn on ironing. thanks though.
0
Reply
Replying to @JarvisDesign
Would you have one of your models you created for an example, I would like and learn from someone with great skills to better myself.
thank you
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
yea why did you copyright my coaster? designed it myself in fusion360 to show you how its done. its not even the same design.
The designer has replied
0
Reply
you are lying,
that was my model sorry.
0
Reply
Replying to @SlowpoksWorksho
Well that's funny because I recorded myself designing it and also have the step files to prove it. Already sent that off to support. And what's also funny is the DESIGN IS DIFFERENT. My text is below the logo, yours is above. Not the same at all. Only thing that is similar is the ring on the outside. And we'll, that's not original to you so good luck. You wanted to see a better model. I showed you one.
0
Reply
Replying to @JarvisDesign
thank you
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
bottom of model was not printed properly not smooth but rough and jagged not sure if issue is with printer or model
The designer has replied
0
Reply
well look at my example, its very smooth, I think its the printer , thx for printing
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Easy print with the AMS and comes out great.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Danke fürs teilen. :-)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld