Search models, users, collections, and posts
Gear Machine
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
52 min
1 plate
Open in Bambu Studio
Boost
2
2
0
0
1
0
Released
Description
This is a simple gear machine/toy made up of three gears.
Post-Printing Instruction:
Orient the base so that the cylindrical studs are in this pattern:
O
O O
2. Put the handle gear (the gear with the tall handle on it) on the right-most stud.
3. Put the other two gears on the other studs.
4. Put the small cover (long rectangular piece with a hole in the center) over the handle gear, it should snap or slide into place between the two little positioning blocks on the base, and push up against another on the opposite of the gear.
5. Put the big cover (the piece made of two long rectangular pieces) covering both other gears, it should snap or slide into place between two sets of positioning block on the grid, and push up above another.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)