Search models, users, collections, and posts
Shelf Bracket
IP Report
Print Profile(2)
STRONG 0.2mm layer, 4 walls, 25% infill
Designer
2.7 h
1 plate
STRONG with Support _ 0.2mm layer, 4 walls, 25% infill
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
258
756
53
20
942
426
Released
Description
Simple Shelf Bracket for wallmounting with screws
Originally designed for IKEA BERGSHULT but every other board or shelf wider than 190mm will also work fine!
It is recommended to use 3 or 3.5mm screws to mount the shelf on the bracket.
For wall mounting, 5.0 or 6.0mm flat head screws with shaft are recommended.
To be on the safe side, at least 25% infill is recommended.
I printed my shelf brackets out of ABS. PETG works too. PLA might not be stable enough, this should be tested.
The model must be printed laying on the side so that the arrangement of the layers is correct.
Boost Me (for free)
Ich freue mich sehr über Feedback und einen Boost ! :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (53)