PART NUMBER 9 of STEEL BALL TRACK ON MAGNETS project!
THIS MODEL IS: Half circle - it's a set of rails to make a half circle to front!
THERE ARE 10 PARTS IN THIS PROJECT:
Launching Tube - to hold your steel balls & launch them to your track! The part can hold 2 balls & when you'll add 1 more - the first one will launch!
Propeller - a cool part that spins when steel ball passes it! You'll need a small pin or a office clip to pass throw this propeller & enter the holding part. Make sure that Propeller moves freely!
Strait Rails - parts to create 10 cm + 15 cm lines (print them as much as you want if you want to get longer rails - just scale the part called "[Strait] Rail" from 100 mm to the needed size)
Tube Down - it's a tube that can move your ball downstairs. print 2 of them to make "C" shape for reverse!
Zig-Zag - this is a fun accessory for a track! the ball will make the zig-zag pass & get downstairs.
Wave line - it's a set of wavy rails - helps to reduce the speed of the ball!
C-shape - it's a FULL 180 degree turn as a tube!
Half circle - it's a set of rails to make a half circle to front!
[THIS MODEL] Spin - a right & left sided spins in a full tube! Suggested to print in transparent filament or resin.
Strait Tube - a tube that steel ball can pass throw! Suggested to print in transparent filament or Resin.
THE FULL MAZE LOOKS LIKE THAT:
EXTRAS FOR STEEL BALL TRACK ON MAGNETS PROJECT:
1. 14mm Steel balls - I ordered 10 pieces
2. N35 Round Magnets - 6X4 size - I ordered 100 but consider order more (6mm diameter, 4mm thick)
* Also you might want to order some bigger magnets - just to support from bottom side your "track parts that ball will hit hard" - will explain it later… [something like that]