DJI Goggles 2 Battery holder with cable snap
Copyright Claim
DJI Goggles 2 Battery holder with cable snap
Boost
63
122
34
Print Profile(1)
0.2mm layer, 4 walls, 20% infill
Designer
44 min
1 plate
Open in Bambu Studio
Boost
63
122
34
6
342
221
Released
Description
Battery holder for DJI Goggles2. Attach your battery and cable to the headband. It is recommended to install it between two pieces of Velcro so that the hard plastic part does not directly contact with the skin. The clip on the holder has a non-slip structure that prevents the battery sliding from one side to the other.
My goggles came with a 36mm headband, and I'm not sure if other regional versions are the same width. Let me know if you have different version.
Print with no support. PLA or PETG
Comment & Rating (34)
All
Boosted
Awesome! It works perfectly, with easy and quick printing, making it a great solution for your DJI floating battery 😊
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
Snug (almost too snug), quick, simple and cleverly made.
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
Ein tolles Gadget für die DjI Brille
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
good
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
easy print.
0
Reply
Could you make a version for just 3 batteries please? I usually keep my last battery in the drone itself. Lovely design though!
0
Reply
huh? this is to hold the battery and coiled cable on the goggles strap while in use. This model doesn't do anything for the drone batteries.
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
Gamechsnger ❤️
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
bottom peeled back on a corner but otherwise came out clean
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
easy to Print, works great!
0
Reply
Print Profile
0.2mm layer, 4 walls, 20% infill
came out perfect, printed in ASA, & ABS
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld