F1 Keychain
Copyright Claim
F1 Keychain
Boost
56
82
26
Print Profile(1)
0.2mm layer, 2 walls, 50% infill
26 min
1 plate
Open in Bambu Studio
Boost
56
82
26
2
204
172
Released
Description
Keychain with only 2 colors.
Comment & Rating (26)
All
Print Profile
0.2mm layer, 2 walls, 50% infill
Las letras "TM" se ven muy mal, por lo demás perfecto.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Didn't have any red in AMS, but green works 😂
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
spettacolare
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
bad finish on top, should be printed up side down
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
muy chulo
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
El perfil ha sido perfecto! Ha sacado la mejor calidad gracias al perfil seleccionado.
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Looks great
0
Reply
Printed perfectly on the A1 mini.
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Good but i recomend scaling it by .2 to get the tm a little bigger
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
I remove the ''TM" to unscale because it was too small to print.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld