Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

34 min

1 plate

4.8(19)

Open in Bambu Studio

Boost

139

Released

Description

Summary

Hier ein Prittstifthalter für das Skadis....Für den beim PCCF mitgelieferten Prittstift
Durchmesser 25mm

Print Settings

Supports:

Yes

                    
                        Notes:                     Stützmaterial :JA

Stützen nur auf Druckbett: aus

Der obere Haken muss gestützt werden

Comment & Rating (21)

@3jyou1ma

Print Profile

0.2mm layer, 2 walls, 15% infill

とても素晴らしいモデルです。

(Edited)

@BuGabriel

Print Profile

0.2mm layer, 2 walls, 15% infill

I recommend going with tree organic support. The tree slim setting that comes with this profile makes it hard to separate the support (if even possible ... I rushed it and broke the upper hook xD ). Other than that it's ok for the BL glue stick (NOT the liquid glue, which doesn't fit).

@chilluniverse

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed like a charm!

@ldubyathree

Print Profile

0.2mm layer, 2 walls, 15% infill

Works as intended

@yepitsart

Print Profile

0.2mm layer, 2 walls, 15% infill

@Sammy1988

Print Profile

0.2mm layer, 2 walls, 15% infill

👍

@StanFrancisco

Print Profile

0.2mm layer, 2 walls, 15% infill

passt alles

@Northsider

Print Profile

0.2mm layer, 2 walls, 15% infill

Great!!!

@JustJesse

Resized a bit for my glue stick, but i love the model

@T.Li55

Thanks for uploading this. Printed fast and easy with no problems and works perfectly for the Bambu Lab Glue stick as well. I used support enabled, Tree Slim, standard settings with the same PLA material i printed the part in. Was easy to remove and didn't leave ugly patches. I painted the gap in the back of the part to make it look nice. Good job.