Container for CR2032 batteries
Remixed by
Copyright Claim
Container for CR2032 batteries
Remixed by
Boost
17
29
14
Print Profile(4)
15PCS 0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
20PCS 0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
10PCS 0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
0.12mm layer, 2 walls, 15% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
17
29
14
0
75
86
Released
Description
Container for CR2032 batteries
The batteries are fixed in the holder and do not fall out of it
But I didn’t like, firstly, the complexity of printing, and secondly, the fact that the container closes only due to friction.
In this deep rework, these shortcomings are corrected.
Options for 10, 15 and 20 batteries are published here.
Optimized for 0.4 nozzle
When assembling, it is better to glue the cover to the holder with superglue.
Comment & Rating (14)
All
Print Profile
15PCS 0.2mm layer, 2 walls, 15% infill
Printed good, just the thread of the cap is. a bit tough to get on. Did a second print with 0.12mm layer height and that had a much better thread. Worth the extra printing time in my opinion.
0
Reply
Print Profile
20PCS 0.2mm layer, 2 walls, 15% infill
Stringy around the threads. Was able to salvage it.
0
Reply
print with pla fit perfect
1
Reply
Print Profile
15PCS 0.2mm layer, 2 walls, 15% infill
This print came out great and now stores all of my batteries in my desk!
0
Reply
Print Profile
20PCS 0.2mm layer, 2 walls, 15% infill
Die Gewinde sind nicht optimal gedruckt. Nach ein paar mal zuschrauben passt dann alles.
0
Reply
Print Profile
10PCS 0.2mm layer, 2 walls, 15% infill
Gewinde muss etwas nachbearbeitet werden, ansonsten aber klasse.
0
Reply
Print Profile
20PCS 0.2mm layer, 2 walls, 15% infill
this is definitely the best CR2032 holder I've seen. great design!
0
Reply
Print Profile
10PCS 0.2mm layer, 2 walls, 15% infill
threads needs a little cleanup
0
Reply
Print Profile
15PCS 0.2mm layer, 2 walls, 15% infill
Funktioniert und passt perfekt
0
Reply
Print Profile
15PCS 0.2mm layer, 2 walls, 15% infill
fitting tight. nice work
0
Reply
© 2024 MakerWorld