Coin Display Case

Its a Coin Display Case built to include a 6x8 inch piece of 1/8 inch thick acrylic. You can buy display cases, but this one is pretty cheap to make! Plus its just one more thing to 3D print. I will attach or upload a version that does not require the piece of acrylic. There is a mounting cut out on the back so it can easily be hung on a wall by a nail, although this thing looks great standing up on an office desk/shelf. Lastly, I HIGHLY recommend running one of the many ironing calibration tests before you print this. The results are so much better, and you should not trust my print profiles ironing values since every filament/printer combination is different.

You can use any 6x8 inch by 1/8 inch thick piece of acrylic, but I bought these ones from amazon.

Assembly Steps: This should be pretty obvious mostly, the only notes are that the insert inserts (the long kit-kat bar looking things) should probably be glued in. Also, the hold in tabs need to be bent into the two slots on the back, this is what keeps the acrylic, and the insert piece from falling out(it's really hard to design a simple solution to this, and this was the best I could do. None of those metal clips on the back of traditional picture frames.) One you bend those into place, slide them the the edges so they're not in the way of the nail when you hang this on the wall.