AAA & AA Akku Battery Riser Nitecore D4 Digicharger
Copyright Claim
AAA & AA Akku Battery Riser Nitecore D4 Digicharger
Boost
10
16
1
Print Profile(2)
V2 Battery Riser
Designer
1.5 h
1 plate
0.2mm layer, 2 walls, 15% infill
35 min
1 plate
Boost
10
16
1
0
26
9
Released
Description
Summary
This is my version to rise AA & AAA batteries so they can charge properly.
There is a grip area to remove the riser easily. The "bottom" part of the riser is flat to enable a good access to the batteries.
It is also possible to leave the riser in place and even use them while the charger is mounted to a wall. They will not fall out.
I printed mine in ASA but every more heat resistant materials will work too. I would not recommend PLA.
Have fun and keep printin!
Update 17.01.2024
Added a V2 Version with a higher middle part to fit even more charger.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
very good. fitted well on SC4
(Edited)
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld