German Shepherd Hueforge

If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full.  Send me a message if you have questions.

If you would like to sell my Hueforges a commercial License is available on Patreon. Link is in my bio.

Important:

1. You CANNOT adjust the Z scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.
2. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown.
3. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses color blending, but it does not show in the slicer.

You may see a floating regions error. This can be ignored.

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA PolyTerra Charcoal Black Transmission Distance: 0.3
PLA Sunlu Meta White Transmission Distance: 6.2

Swap Instructions:
Start with Charcoal Black
At layer #9 (0.8mm) swap to White for the rest.