22LR Ammo Case - 100 Rounds by KiCkiN

KiCkiN

Hobby & DIY>Sport & Outdoors

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

22 LR Slider V2

Designer

1.8 h

1 plate

4.7(20)

22LR Slider V1

Designer

1.8 h

1 plate

4.5(2)

Just Tray Insert - Tighter Insert for v1

Designer

38 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

139

243

Released

Description

11-11-2023

Added v2 with tighter tolerances
Added tighter tolerance insert for those that just need tighter insert after printing v1

.22 LR ammo case that holds 100 rounds

If the tray doesn't fit snug: Place a drop of superglue on each post and then press the tray onto the posts. Let the glue fully dry and before placing ammo inside, or before sliding the lid on. This is to prevent any superglue residue or “bloom” from getting on your ammo and lid.

If lid it too loose/tight when sliding you can scale the Y-Axis up/down by 0.2. If you do this make sure that Uniform Scale is NOT checked and only the lid is selected.

Comment & Rating (31)

@Shawn_standridg

Print Profile

22LR Slider V1

inert could be a tad bigger for a tighter fit

The designer has replied

@KiCkiN

Thanks for the feedback. Do you mean the entire insert itself is a tad small, or the holes are too small? Let me know and I'll upload a fix.

@Shawn_standridg

Replying to @KiCkiN :

the insert has a tad bit of slack each direction

@KiCkiN

Replying to @Shawn_standridg :

Gotcha. I just put glue on top of pylons or whatever youd call the posts that the insert sits on to hold the insert in place. But I'll upload a tighter fit insert sometime tonight.