"Christmas Minion 3D Model" 🎄🌟

Celebrate the holiday season with a touch of Minion magic! This delightful 3D model of a Christmas Minion captures the festive spirit and adds a dash of cheer to your holiday decor.

⚠️ For larger models, remove the purge line at the beginning of printing! ⚠️

Bambu Studio Settings:
The settings are just a recommendation, however you can print with the settings you are already used to using!

• Preferences (ctrl + P) → activate developer settings → Quality →Advanced → First Layer Flow Ratio: 1.04
• Quality → Wall generator → Arachne
• Quality → Wall transitioning threshold angle → 50º
• Strength → Advanced → Infill/wall overlap → 20%
• Quality → Advanced → Avoid crossing walls
• Increasing retraction / reducing temperature can help reducing wisps
• I recommend always starting with the lighter colors.

Recommendations before and after printing:

• Use textured PEI sheet

• To make the hole for the USB cable input for the LEDs, you can do it with a soldering iron, drill a hole or you can do it with a slicer by adding a negative model in the place where you want to make the hole

• For the pieces to give more light, I recommend using aluminum tape on the inside of the back cover

• Be careful to clean the table well

Materials and tools used to assemble parts:

• Aluminum Tape for the back cover
• Hot glue pistol to place in the spacing of the LEDs so they don't come off

• Soldering iron to make the hole for the USB cable and/or to solder the LEDs with the USB cable with ON/OFF switch

• White or RGB LEDs

To find out the list of all the components I use, you can click on the link in my description, and you will find it in the first post!