Apple watch charger mount
Apple watch charger mount
Boost
10
20
15
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
Designer
36 min
1 plate
0.1mm layer, 2 walls, 15% infill
1.4 h
1 plate
Open in Bambu Studio
Boost
10
20
15
0
63
76
Released
Description
A simple nightstand mount I made for my Apple watch charger.
I have made a small recess on the backside to accomodate for the thickness of the doublesided adhesive.
I always recommend 3M VHB tape for any project that requires such mounting.
Standard PLA print with no special settings needed.
Questions are welcome and please like, rate and share.
Comment & Rating (15)
All
Great model! prints fast and works great. thanks!
The designer has replied
0
Reply
wow, nice colour 😃
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
The design is overall good. The cable clamp for the button is not tight enough if the model is not taped to a surface. It is worth noting that this model is for the USB-C version. I have made a remix of this that is compatible for the USB-A version.
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
the cable is tight in there. I think I would’ve needed more support
The designer has replied
0
Reply
Hi Alberd_m
Thanks for the rating.
The tightness is by design to ensure that the cable stays in the groove, instead of hanging down, being more visible.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Struggled to get my cable in but after some sanding it was good
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
printed great. Worked exactly as I hoped. thank you for the model.
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
not perfect but very close
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld