Pliers/Cutter Holder for Peg Board
Copyright Claim
Pliers/Cutter Holder for Peg Board
Boost
23
55
13
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
23
55
13
1
101
107
Released
Comment & Rating (13)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
The angle of the top hook is a bit tricky to get into the peg board but it works after i drilled the hole out.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice space saver
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue
Other Issues:DId not fit into Multiboard and snapped in same spot 2 times
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:very weak when printed with PLA, all three broke within minutes
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld