Search models, users, collections, and posts
iPhone Pro Max Joy-Con Controller
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
0.2mm layer, 2 walls, 15% infill Gyroid
2.7 h
1 plate
Open in Bambu Studio
Boost
58
92
23
3
122
65
Released
Description
I designed this joy-con controller to be easier to print and use, not requiring any supports or Nintendo parts for the joy-cons. It was designed specifically for an iPhone 14 Pro Max with an Apple case installed, though it works with the few cases I have. The iPhone slides in the top and is held in place with a back brace and front rails.
I recommend PLA and the cool plate to avoid warping on the joy-con rails as this prints upside down.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (23)