Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Adjusted object filling, modified print joints
1.8 h
1 plate
Open in Bambu Studio
Boost
143
313
77
10
431
478
Released
Description
Slightly twisted ring holder.
Comment & Rating (77)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Daughter loves it. Printed perfectly.
1
Reply
Hey! what you select for seam position?
0
Reply
Replying to @ingar138
Unfortunately I don't recall for this print, but I typically use aligned.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
design is good but print profile is not: Few walls, little preparation in making print profile, random print splice ruining the design.
0
Reply
Dry your filament! It will work fine!
0
Reply
Replying to @ruth.irons
it is not about umidity, open my print profile and check... you just need to add some upgrade to get this print profile perfect as it deserve!
0
Reply
A1, all good.
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed on sport mode. happy with the output
The designer has replied
1
Reply
Nice!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
joli modele
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
temp bad, config no good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
X1C, 25% sparce infill, random seam, 0.12mm hq @BBL X1C.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect
0
Reply
Boosted
A1. perfect.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld