Boat Flag Mount

Have a couple of flags that I want to hang from the 1" posts on the bimini top on my boat. Printed in PETG (blue). It is just a smidge bigger inner diameter than 1" so there is a screw to snug it down. Note that the threads on the screw are fine so that it holds, but also makes it a pain to get them started. If you find they are too snug, which can be due to printer, filament, etc. you can size them up or down accordingly in the slicer. You could also use a couple wraps of grip tape and clamp over it if you don't want to use the screws.

These clamps aren't really meant to be put on, taken off, put on, taken off, though they will come off easily enough if you need to remove them.

IMPORTANT: If you have a FAST boat, I highly recommend you use an actual carabiner between the mount and the flag. The included printable version is strong, but I doubt it's strong enough for a fast boat across the water. Your call, you've been warned! :)