xtouch P1P/P1S Chamber Temp Enclosure remix
Remixed by
Copyright Claim
xtouch P1P/P1S Chamber Temp Enclosure remix
Remixed by
Boost
20
37
34
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Boost
20
37
34
0
107
127
Released
Description
A quick rework of the enclosure to better fit the DS18b20 temperature sensor. Sensors I received, the surface mount components were in the way and would not slide into the enclosure fully. You do still have to trim the bottom of the sensor posts with side cutters but it should slide in now tightly. Nice enclosure.
Comment & Rating (34)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Needed to shave off some plastic in the slider as it was touching components on the card.
and remove some of the pins.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good model.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Can you please show me where you mount the sensor in the chamber of the printer?
The designer has replied
2
Reply
Ran the temperature wires from the xtouch which is mounted on front of the printer and through the spacer print. The wires ended up internally next to the internal usb port so the sensor sits on the shelf next to the usb port for me. You could put it anywhere else out of the way as long as your wires reach.
https://makerworld.com/en/models/49439#profileId-51313
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints and fits perfectly.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works as described
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sensors fits well! used PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Okay, but does not fit the module I bought on AliExpress.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
doesn’t fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this should be a Remix not the Original... now the Sensor didnt fit, cause its the same size
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld