Thanks for the rating! That's a great question and sharp eye! The ones you see in my pic were remixed by a remixed model that does not allow remixing, so I cannot share those models, unfortunately. I didn't know license restrictions could allow remixed models not to be remixed until I was about to upload the remix. I don't see the logic in that, but whatever 🤷🏻‍♂️ However, I have re-remixed them from the original model (non remixed version), but I'm having trouble with the center of the leaf not filling in for some reason. I cant figure out why its leaving a gap even though these are the same exact leaf model and size as the ones in my AMS. But now that I know there is more interest in them, I'll get back to the drawing board and see if I can figure out that gap issue. I'll keep you posted if I'm successful and upload the model.

Check out my other models, I have a larger door handle with a cannabis leaf on it as well! 😎 Here's the link: https://makerworld.com/en/models/89756#profileId-96081 EDIT: Looks like you found it already 🤘🏻 Thanks for the rating on that as well!

Yeah I have both the door handle and the top glass knobs thanks to you :). A little feedback for the leaf not getting fully filled in the middle, for some interesting reason my first small knob print had the same thing on textured pei plate, printed it again and no issues, fully filled in the second time on the same print profile on the same bed. I think there is a small difference every time the printer does bed leveling and on small details with multi color prints, it effects the first layer sometimes. One could fix it themselves easily by adjusting the filament profile to overe-extrude a bit if you upload the design at its current version. I would definitely be interested in that ahahaha

Looking great! 🔥🔥

Thank you!