Micro SD Card Storage
Remixed by
Copyright Claim
Micro SD Card Storage
Remixed by
Boost
27
56
3
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Boost
27
56
3
0
125
38
Released
Description
I don't have or use the larger SD cards, haven't for a while so didn't want all the extra space taken for them. I removed them and made the box a little smaller to just hold Micro SD cards.
I also added a couple with raised and recessed lettering with "Micro SD Storage" on the top.
Comment & Rating (3)
All
I had mine fail at the start of the hinge this was printed with a 0.4 nozzle and extra fine 0.08mm I wonder if it was due to the extra fine preset, I will try your preset directly hopefully I get better results.
ps I should of taken the photo before I cleaned out the small amount of spaghetti
The designer has replied
0
Reply
Hopefully you were successful with your second attempt.
(Edited)0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld