Search models, users, collections, and posts
Light Switch Cover
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 100% infill
Designer
5.9 h
10 plates
Snug supports, 0.2mm layer, 2 walls, 5% infill
24 min
1 plate
Open in Bambu Studio
Boost
153
462
58
45
627
506
Released
Description
Light switch cover for unwanted switching of the lights.
Should you want to switch the light, the cover can easily pop off without unscrewing the bracket by squeezing the side or top depending on one gang or two gang version.
Bracket installs using existing light switch cover plate screws.
Make sure to print the cover top down to the print bed. Everything can be printed without support. If the bracket locking tabs don't fit properly then consider printing the bracket with support for the tabs.
:: Update 01.14.25 ::
- Added print profile with 10 plates, some with both bracket and cover, some with bracket only, and two with cover only. So if you want different colors for the bracket and cover you can print them separately.
- Covers are the same on all plates, only the brackets have two tolerance versions so pay attention to those when deciding which to print.
:: Update 03.04.22 ::
- Added .2mm wider bracket opening tolerance for both version to allow easier insertion of the cover. Use .1mm tolerance version for a tighter fit if you like it tight! :P
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (58)