Foxy Clip
Copyright Claim
Foxy Clip
Boost
77
132
32
Print Profile(4)
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
Designer
28 min
1 plate
2x Normal size PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
Designer
50 min
1 plate
1x Large (130%) PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
Designer
42 min
1 plate
4x FoxClip - 0.2mm layer, 5 walls, 15% infill
1.7 h
1 plate
Boost
77
132
32
0
173
257
Released
Description
Edit: Thank you all for downloading and liking my foxy clip!! You're funding this college student 3D printing addiction <3!!!
Say hello to the Foxy Clip! This little fox isn't just cute, it's also incredibly practical! Designed to help protect your snacks by keeping them shut. This little Foxy clip also works well as a general clip.
Important!
The Foxy Clip is designed to be printed with PETG (PLA+ should work). These materials were chosen for their ability to flex slightly, which is crucial for the funcionality of the clip. Please Note that using a filament with a low threshold for permanent deformation or high brittleness may result in less than optimal performance.
Comment & Rating (32)
All
Print Profile
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
Printed really well. Works well. Thank you!
Printed in Bambu PLA Tough Vermilion Red.
1
Reply
Print Profile
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
turned out nice with PETG
1
Reply
Print Profile
2x Normal size PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
Really nice, clean print!
0
Reply
Print Profile
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
fonctionne bien :)
1
Reply
Print Profile
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
prints great! thanks
1
Reply
Print Profile
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
These stretch to the size needed once and then lose the abilty to propery hold a small bag closed again. Cute for a one time use if printed with pla.
0
Reply
Print Profile
1X Normal size, PETG/PLA+ 0.2mm layer, 4 walls, 15% infill
Great, print profile and great quality. Printed a bunch of these for the junk drawer.
0
Reply
Print Profile
4x FoxClip - 0.2mm layer, 5 walls, 15% infill
2
Reply
Print Profile
4x FoxClip - 0.2mm layer, 5 walls, 15% infill
2
Reply
Print Profile
4x FoxClip - 0.2mm layer, 5 walls, 15% infill
(Edited)
2
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld