8mm Lead Screw Grease Applicator for Super Lube 3oz 21030 Tube
Remixed by
Copyright Claim
8mm Lead Screw Grease Applicator for Super Lube 3oz 21030 Tube
Remixed by
Boost
281
578
197
Print Profile(4)
PETG - 0.16mm layer, 4 walls, 20% infill, by object
Designer
1.4 h
1 plate
0.16mm layer, 3 walls, 15% infill, PLA
46 min
1 plate
0.2mm layer, 2 walls, 25% infill
36 min
1 plate
Inside brim for cleaner details 0.16mm layer, 3 walls, 15% infill
46 min
1 plate
Boost
281
578
197
12
864
615
Released
Description
I made a remix of this grease packer so it can be be used to quickly and easily apply PTFE grease to 8mm lead screws. Specifically fit to the Super Lube 21030 (3oz) tube so I can get it on the rear lead screw on my Bambu X1 much easier. Works great!
Comment & Rating (197)
All
Print Profile
PETG - 0.16mm layer, 4 walls, 20% infill, by object
great idea
The designer has replied
2
Reply
Thanks! Even if it's just for getting to that rear screw, it's worth every second of print time 😅
(Edited)1
Reply
Print Profile
PETG - 0.16mm layer, 4 walls, 20% infill, by object
works great thanks for the design
The designer has replied
1
Reply
Glad it's helpful for you!
0
Reply
Very nice model - thanks! It fits the Super Lube 92003 (3 oz) tube also.
The designer has replied
1
Reply
Looks good, hope it helps your maintenance routines!
0
Reply
Print Profile
PETG - 0.16mm layer, 4 walls, 20% infill, by object
Came out great.
The designer has replied
1
Reply
Looks good, hope it helps!
0
Reply
Works with Lucas too. Just cut the nozzle part off to the threads.
The designer has replied
1
Reply
Good to know, thanks!
0
Reply
Print Profile
PETG - 0.16mm layer, 4 walls, 20% infill, by object
Good print. Looks great in clear PETG. haven’t actually squeezed any grease through it yet, but fits on tube good and looks like it will work good.
(Edited)
The designer has replied
1
Reply
Looks good! I made the opening just big enough to work but not so big that it'd spurt everywhere 😂
Controlled flow was the idea since you really don't need much!
0
Reply
Really well done, thanks
The designer has replied
1
Reply
Thanks, I hope it helps!
0
Reply
It fits well and prints without any problems, good work 👍
The designer has replied
1
Reply
Thanks!
0
Reply
Print Profile
PETG - 0.16mm layer, 4 walls, 20% infill, by object
nice
The designer has replied
1
Reply
Looks nice in black!
0
Reply
Thanks for sharing, it works great!
1
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld