Search models, users, collections, and posts
cake cutting template
IP Report
Print Profile(1)
0.24mm layer, 4 walls, 15% infill PLA high only 30mm
Designer
1.9 h
2 plates
Open in Bambu Studio
Boost
56
188
2
0
83
46
Released
Description
3CM tall prints for faster printing
The printing of the is set from the top to the bottom.
If you print from PLA or PETG then just rinse, if you print from a PC you can also wash it in the dishwasher afterwards.
How to use?
Place on the cake and then cut according to the marked lines and then you have 10 or 12 equal pieces of cake.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)