Search models, users, collections, and posts
Soap holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
8
13
6
1
32
15
Released
Description
My first model, I hope you like it. Just a simple soap holder that will allow the bars to dry out after each use. This will make your soap last so much longer. will print with no supports with no issue. I print mostly the .28 but also uploaded the .2 in case you would like it to look nicer. I normally just print in PLA and clean when I clean my shower. PETG may hold up better over time but honestly I just print a new one when needed
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)