dinosaur block style
Copyright Claim
dinosaur block style
Boost
56
60
21
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
56
60
21
1
201
208
Released
Description
fun little dinosaur.i am new to cutting and joining so giving this a try
Comment & Rating (21)
All
quick print
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
parts of the model are barely attached and it aint even lego scale its tiny
0
Reply
That is Beacuse You Did Not Scale It
0
Reply
Replying to @user_190748991
how should i scale it then? also why not scale it properly to begin with
0
Reply
Replying to @biingbong
I Can scale On Creality Print
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Support Issue:head design is to weak and will fail
Strength Issue:pivot at kneck is poor design and easily snaps off
Other Issues:very tiny but scaling up only worsen the kneck and head pivot design
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
a little small but quite coool
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
didn't work out so good for med but might be my filament
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Strength Issue:Printed well but the head breaks off every time
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld