Little bathtub tug boat by vandragon_de

vandragon_de

Toys & Games>Other Toys & Games

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

9 h

1 plate

5.0(3)

3HR, 1 color. 0.2mm layer, 2 walls, 15% infill

3.2 h

1 plate

5.0(6)

Open in Bambu Studio

Boost

179

Released

Description

Growth for my bathtub fleet. A little tugboat.

I had seen a great 3d picture of a tugs and I couldn't get that out of my head. Unfortunately, I don't know where I saw it. So I tried to draw it out of my head. The model was created on this basis.

I drew two versions. One with open cabin and one with closed. The highlight of the open version is a variation of Larry the Engineer (Makerbot) as captain. The tug can be used on land, then you don't have to pay attention to anything. However, if it is to be floatable, the fuselage must be printed with two different fillings. Otherwise the boat is too light.

Bottom: 40-50% Infill
Top: 10% Infill

The models on the pictures are printed with 70% of the original.

Comment & Rating (9)

@user_1988742622

Print Profile

0.2mm layer, 2 walls, 15% infill

Came out great, thought I could add some more color changes and a custom name since colors were changing on those layers anyway in the pre-color model, so didn't add many more color swaps. My poop shooter was backed up and affected the quality (my bad) but even with that it came out great! All the infill included made it float great and feel like quality.