Ammo Box (223, 556) by Boerni

Boerni

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.9 h

2 plates

4.9(24)

Open in Bambu Studio

Boost

121

223

273

Released

Description

This is an ammunition box for 223, 556 rounds. The rounds can be stored individually or as strips of ten. The lid has a snap device.

I made a new V2 version with a stronger lid. It is a little bit smaller (no strip support):

https://makerworld.com/en/models/629726#profileId-554519

Comment & Rating (39)

@ibelieveicanfly

Print Profile

0.2mm layer, 2 walls, 15% infill

Strength Issue:The top piece sides need to be stronger due to the tight fit when removing the top piece from the bottom. overall the print is solid just that minor issue. Great work 👍🏾

The designer has replied

@Boerni

Thanks! I'm working on a new version at the moment. I will try a 1,6 mm instead of the 1,2 mm wall.

@Boerni

Hello, the latest version is available: https://makerworld.com/en/models/629726#profileId-554519

Show original

@user_3103349143

Print Profile

0.2mm layer, 2 walls, 15% infill

great

@cookcrafted

Print Profile

0.2mm layer, 2 walls, 15% infill

super nice finish on these. excellent for for the lid. super tight but put in on and off 20x and it's perfect. I did have a bit of lifting on the edges as the bottom doesn't sit perfectly flat on the 2 I printed. very minimal.

The designer has replied

@Boerni

I had no problems with PLA. If you use PETG you should use a brim, or the "add primitive" function of the slicer. There you can put discs on the edges.

@thom97ga

Print Profile

0.2mm layer, 2 walls, 15% infill

Works great. A little tight on the lid but it works perfect.

(Edited)

@user_3149349386

Boosted

I love this box. would love to see the same box in 308

The designer has replied

@Boerni

A friend of mine has 308, maybe I will make a box for 308 too.

@user_3149349386

Boosted

that would be so great. the fact alone that the tips go down make these battle boxes outstanding. they are perfect for the range and it hunting. my next step is going to be to learn to design prints. I’m sure this will take time to get good at but I think it will be worth the effort

@cookcrafted

the photo shows a strip to hold them. I don't see that in the file. am I missing something

The designer has replied

@Boerni

Hi, some sort of ammo are sold with this stripes. You can use them for a speedloader, but you don' t need them for the box.

@cookcrafted

Replying to @Boerni :

I found a file of one and it works great. Thanks! I then printed a bunch of perfect sized 223 and filled the box for a display :)

@thesawmillshop

Print Profile

0.2mm layer, 2 walls, 15% infill

Boxes from which you can use strippers clips are surprisingly uncommon

@user_206377631

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

perfect for my needs, ty

@mikeymakesshat

Print Profile

0.2mm layer, 2 walls, 15% infill

Came out perfect. Others mentioned the lid being tight. The first few times you put it on, start the lid at an angle rather than trying to put it on square to the base container. After a few on/offs, it’ll fit perfectly. 😁