Skadis - Simple Tape Holder
Copyright Claim
Skadis - Simple Tape Holder
Boost
54
148
15
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
40 min
1 plate
Boost
54
148
15
0
198
111
Released
Description
A simple tape holder for Ikea Skadis boards.
For a version for a smaller rolls, see https://makerworld.com/en/models/104736#profileId-111763
For a larger version which works nicely for duct tape, https://makerworld.com/en/models/207583#profileId-227690
Comment & Rating (15)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
came out good, but it’s a little short for a roll of duct tape
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
2 of 3 broke, layer lines are not optimal orientation, more susceptible to breaking apart
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
for rather small tapes but printed well
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Great model. Snug fit.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld