Door Stop

I don't believe this was originally my design, I printed it years ago and don't remember, it finally broke and I could not find the file again so I remade it. If it is yours let me know so I can credit you properly and link the original.

I remade this after the one I had used for years broke. remade it and made a few changes.

both end parts, wall part and cap should be printed in TPU so it doesn't damage door or trim, I used polymaker.

I printed the body in polymaker nylon CF-6 so it doesn't crack after a few years like the other one I made in pla.

remade it to work with:

1 - m4 x 50

1 - m4 nut

1 - m3 x 18

1 - m3 nut

To Install:

Remove the pin from the top hinge on your door, slide pin through hole and replace hinge pin.