Stream Deck Holder X2

This is my first uploaded project. Inspired by the project by @MRCLKSR_133970 on Printables, I wanted a holder for the Stream Deck+ and the 15 button version only. I beefed up the weight with higher sparse infill and used the gyroid pattern for extra strength. I couldn't be happier with how this came out. Printed it in orange Polymaker Polylite PETG. Needs support's and inside and outside brim's to make sure of bed adhesion. Had a small amount of stringing but nothing a few swipes of a deburring tool couldn't fix. Prints in a single piece on a single plate. If using all my setting's it took 16 hours and 33 minutes. Worth every second if I say so myself!!

Lots and lots of thanks to my buddy Nick for all the help!! Couldn't have done it without you!!