Spray Can Holder

Copyright Claim

Spray Can Holder

Boost
14
42
8

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, Strength Profile, Gyroid Infill
0.2mm layer, Strength Profile, Gyroid Infill
Designer
3.1 h
1 plate
4.7(6)

Boost
14
42
8
4
85
97
Released

Description

Wall mounted spray can holder. Will fit most off the shelf spray cans of lubricant/paint eg: WD-40 etc. Internal diameter is 68mm and is 90mm tall. 40mm hole spacing which is also printed on the model itself. Can be fastened using up to M5 countersunk bolts or common wood screws. I printed mine out of PETG but PLA or ABS would also be fine.

Comment & Rating (8)

Please fill in your opinion
(0/5000)

Not sure why the description says it's for 58MM cans. The opening is definitely for 68mm cans. Which is unfortunate, since it's too large for my use.
The designer has replied
0
Reply
Apologies for the mistake (and the wasted filament). Thank you for pointing out the error, I'll update the description. Would you like a 58mm version provided?
0
Reply
Print Profile
0.2mm layer, Strength Profile, Gyroid Infill
my bad
Other Issues
0
Reply
Print Profile
0.2mm layer, Strength Profile, Gyroid Infill
Easy print- I had 2 different size cans. The original was great, I did have to scale it up in BStudio for a different can that didn’t fit the original design.
0
Reply
Print Profile
0.2mm layer, Strength Profile, Gyroid Infill
0
Reply
Print Profile
0.2mm layer, Strength Profile, Gyroid Infill
0
Reply
Print Profile
0.2mm layer, Strength Profile, Gyroid Infill
0
Reply
Print Profile
0.2mm layer, Strength Profile, Gyroid Infill
(Edited)
0
Reply
No more