kraken
Copyright Claim
kraken
Boost
114
213
45
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
8.2 h
1 plate
0.2mm layer, 2 walls, 15% infill, no brim
8.2 h
1 plate
Boost
114
213
45
3
278
315
Released
Description
my print in place kraken no supports needed
Comment & Rating (45)
All
Haven't even printed this because the model is broken. the bottom has floating regions (it isn't flat) and you can't drop it through the build plate far enough to fix it, because the connecting joints are far too thin. I'm assuming the uploader didn't design it as they really should have noticed and fixed the issues prior to upload. Would have liked to print it, but not wasting filament on a broken model.
(Edited)
2
Reply
what a kraken good time for my kids
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
turned out great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I printed this twice and it broke in the same spot both times. My kids still loves it though.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
was a great print. my son loves it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
came out nice at original size
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
looks great but extremely fragile. my kids dropped it and the legs broke off.
0
Reply
looks amazing but is fragile. my kids dropped it once and two legs broke off. the connection points are fragile. but this is a REALLY nice model.
0
Reply
prints great. Wish the connection points on the legs were a little stronger. But this am-zon filament has had a lot of issues. so that Malay be the problem.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great! pla silk with no supports
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld