SKÅDIS Glue stick holder and Allen keys
Copyright Claim
SKÅDIS Glue stick holder and Allen keys
Boost
8
20
9
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
50 min
1 plate
Boost
8
20
9
0
31
21
Released
Comment & Rating (9)
All
çöp
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
doesnt fit the skadis
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
it printed fine! but the hatch on the back is not great, perhaps I should have printed it differently- but I did print it with support. it just falls of so fast from my pegboard.
0
Reply
Does not work with skadis
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Druck ist gut, Modell nicht
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Not compatible:(((
(Edited)0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Other Issues:Non-compatiable with the target board (skadis)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld