If you are to lazy to use your standard Hand-Pump, you can use this tool for your Dyson (V8, 9, 10, 11, 12, 13, 14, 15, 16) instead.

You need:

A Dyson,

A 27mm Gasket,

A 3D Printer :).

I only hotglued the gasket into place and then it's finished.

I used:

Vac Bags:

https://www.3djake.at/3djake/vakuumbeutel-5er-set?sai=9183&gclid=Cj0KCQjw4vKpBhCZARIsAOKHoWTTr6auQt5UMzpvfQ-SakTfhPzDpNzKTnsdnCo_t6FENVoR9dLV4MgaAoi8EALw_wcB

Gasket:

https://www.amazon.com/Houseuse-Gasket-Rubber-Washer-Grommet/dp/B075YV1BW4