SECURE BUILD PLATE HOLDER (INTERLOCKING, FITS 5x BUILD PLATES)

This build plate holder attaches to a rear corner of newer Bambu Lab P1- and X-series printers (March 2023 and newer).

IT DOES NOT FIT OLDER MODELS (February 2023 and earlier).

• VERY stable build plate holder
• Holds up to 5x build plates
• Narrow foot print
• Stops plates from going too far back
• Prints in only 3 hours and uses 220g of filament (this is required for stability and tensile strength)

INSTRUCTIONS:

1. This print is meant to stand on the RIGHT side of the printer. If you want it on the left side, you must mirror it in the slicer before printing. However, most people have their poop bucket and filament feeder on the left side of the printer, so odds are you want this plate holder on the right side to avoid collisions or clutter.
2. Print it (duh)
3. Tip the printer slightly towards the front, slide the interlocking corner ring of the build plate holder underneath the printer. Set the printer back down gently, and adjust the position of the build plate holder if needed, as you lower the printer's corner fully.

That's it. Now fill it with your 5 build plates.