Star Wars logo light box / sign
Copyright Claim
Star Wars logo light box / sign
Boost
41
73
11
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.4 h
2 plates
Boost
41
73
11
0
124
29
Released
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed perfectly. no problems at all.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
plate 1 need to be flipped around, cant print in air.
The designer has replied
1
Reply
I just checked and it was layer properly. i reuploaded just in case
0
Reply
I had issue with this print also, and Creator reported my low review as misinformation, but it went to spaghetti each time it went to the text layer
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
first time I attempted to print didn't realize it wasn't face down and it failed. imported to bambu studio to flip model and attemlted print face down. failed again . third tike failed again...
The designer has replied
0
Reply
Did you let it cool down completely? If not it will tear.
0
Reply
Replying to @xeebo00
It didn't complete before it started failing. Barely a few layers in . I haven't had any problems with any others models, just this
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Pretty good
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
strings each time it gets to the logo layer. this print profile isn't it for me
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld