Emergency (door) STOP!
Boost
65
113
14
GIF
Print Profile(1)
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
Designer
3 h
2 plates
Boost
65
113
14
0
113
102
Released
Description
Everyone knows those funny red buttons that.. for some reason, no one ever presses.
But now, you have the chance to put them where they would occasionally be used.
Under certain circumstances, at least for the "unknowing", this can also create a bad conscience if they open the door too quickly. ;)
Can be printed fully in PLA or PETG, no need of any Support or TPU material.
You can download the plain knob and add your own text.
Grease the inside of the button a little to avoid weird plastic rubbing sounds!
The *.gif based reliability test is in full swing:
Comment & Rating (14)
All
Nice
1
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
works perfectly ! the spring works great even in PLA ! thank you I’ve been wainting to print a button for a long Time but i couldn’t find a model
1
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
The font could be more legible
0
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
1
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
After printing it in PETG, the corners lifted a few times. However, I added a raft and it printed perfectly.
1
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
Overall nice design. I just had to reprint several times the button as the text was not coming out properly.
1
Reply
please make one for a1 mini
0
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
1
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Red/White Knob_ 0.2mm layer, 2 walls, 20% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld