D&D dice & figurine holder I made from scratch using TinkerCAD. I had a few 'Tosnail 2 oz Clear Plastic Square Dessert Cups' laying around and wanted to make a dice holder that would accommodate them. The clear plastic cups are great because I can take them out, and flip them over into my hand, thus saving the time of trying to fish them out.

The magnet pillars on each corner will fit a 5x3 mm circle magnet. I sized the holes on the top and bottom to 5.3mm diameter to allow for easy installation. On my Anet A8 the magnets fit in fine, but on my Ender 3, I had to use a 13/64 inch drill bit to bore out juuuust enough material for the magnets to fit.

Underneath the box are magnet holes so the lid doesn't have to roam free or be put away during your game.

This was my first time making anything from scratch in TinkerCAD, and I hope y'all enjoy it as much I had making it!