DEAD CAT Helloween Lightbox or Lamp
DEAD CAT Helloween Lightbox or Lamp
Boost
41
65
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7 h
3 plates
Boost
41
65
3
0
50
43
Released
Description
Dead Cat Lightbox printed on BambuLab P1P.
For best results print the front faces on textured plate.
Add white light LED strip inside and it is ready to decorate your home for Helloween.
There is a small hole on the back lid for the LED cable.
Comment & Rating (3)
All
Wonderfull! Printed 2 of them, came out wonderfully.
Just some thoughts, there seems to be issue with the backplate, it is not flat, and i printed the top of the backplate, the inside, white, so the reflection of the lights are better reflected.
(Edited)2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
...good print, but as mentioned before, the backlid seems to be uneven.
I printed it with z -0.5 and it turned out fine
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld