Welcome back witches and wizards!

I designed this collapsing wand, it's pretty straight forward.

Watch this short video for printing an assembling:

I recently updated the files, you can now choose from parts 2 if you want to print all inner pieces at once (2.1) or one by one (2.2.1 - 2.2.4) in vase mode. For the smallest of the inner pieces there is one hollow one (2.2.1 ... hollow) and one massive one (2.2.1 .... massive).

I also added a version with slant (looks cool at the final built) for Section 2 and 3 of the shaft.

There are now several end knobs to choose from: 3.1 (all screw tops at once, the buttom one with my logo) 3.2 flat, 3.3 a round one and 3.4 the top screw ring as single file.

ONE IMPORTANT SETTING IN CURA:

I use cura as a slicer, I had to put my HORIZONTAL EXPANSION to -0.1, for the telescope parts, so these CONSIST ONLY OF 2 LAYER LINES beside each other. This may also print without this setting, but it worked great for me.

Of course you can also print the single pieces in vase mode.

Make also sure NOT to use supports for all the parts.

The rest was just printed with 0.2mm Layer height and 20% infill.

Of course it is possible to use different colors for all the parts.