I created to house my gaming headset in a discreet way under my desk, as I appreciate a clear minimal desk space.

I've been through a number of versions on this and side printing with print bed supports seems to give the best finish.

I find about 5-8mm of supports below the models seem to work best on my Ender 3 V3 SE, bed adhesion seems a little off, but that could just be me.

Before installing to your desk, test that your screws snap in nice and firm to the headset hook.

Match up the orientation of the guide to the headset hook - The guide is to be placed on the underside of the desk, don't screw the screws all the way in, leave out a few mm and adjust as you need to.

I'm using a 3mmx25mm countersunk wood screw and work ok with this, though a little wobbly if you're wiggling it on purpose, but otherwise I don't notice.

Any questions, just drop me a message!

I am currently working on version 2, with arrows to match up from the guide plate to the unit as well as breakable screw stops. Though still learning Fusion 360.