King Of The Hill Board Game

Copyright Claim

King Of The Hill Board Game

Boost
20
42
3
GIF

Print Profile(3)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

PLA, AMS required, MultiColor Letters for Rules on Back
PLA, AMS required, MultiColor Letters for Rules on Back
Designer
7.4 h
4 plates

PLA, No AMS, Single Color Letters
PLA, No AMS, Single Color Letters
Designer
7.4 h
4 plates

A1 Mini ONLY - 88% scale
A1 Mini ONLY - 88% scale
Designer
6.4 h
4 plates

Open in Bambu Studio
Boost
20
42
3
0
8
2
Released

Description

King of the Hill is a two-player board game of strategy and mind reading to bluff your way to the top of the tower! Place a card higher than your opponent’s card in each of the six trays around the board. Stack chips up the tower according to how much higher your number is than theirs. Be sneaky. Outguess their strategy and use it to your advantage. Block them, then bluff them into wasting their high cards trying to block you. But remember, they’re trying to do the same thing. Change up your strategy, be unpredictable, and climb to be the first to reach the top of the tower and become King of the Hill!

 

 

Game Rules: (Also printed on the back of the game)

To setup, both players place 3 of their chips: One chip on each of the bottom steps of the 3 stairways closest to them.

Play in rounds repeating steps 1 thru 3 until a player makes it to the top space!

  1. Each player chooses and places one card face down in each of the 6 card bins
  2. Flip over pairs of cards in each bin one-by-one
  3. Note which player had a higher # for each staircase. If it was the player with their chips already on that stairway, they climb the tower by stacking the number of chips equal to the difference between the two cards on that stairway. If the other player’s card is higher, no chips are placed.

Comment & Rating (3)

Please fill in your opinion
(0/5000)

no a1 Mini profile 😢
The designer has replied
0
Reply
@Tesigner I just uploaded a print profile at 88% scale so that this model can be printed on the Mini. Unfortunately the base model doesn't fit in the A1 Mini print volume. I don't have a Mini myself, so I cannot verify the quality of the print. If you give it a try please report back with how it works out. Thank you!
(Edited)
0
Reply
thank you!! I’ll try it!
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.