Gyro Fidget Keychain
Copyright Claim
Gyro Fidget Keychain
Boost
3
3
2
Print Profile(1)
0.16mm layer, 2 walls, 10% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
3
3
2
0
2
1
Released
Description
A simple spinning fidget key chain. It's recommended that your printer be well tuned so the print does not fuse together. This model is designed to be on the tighter side, to fidget with, not to spin freely. Will fit standard key rings.
For commercial rights please message me.
If you like my work please consider a tip! https://buymeacoffee.com/vogel3dcrar
Comment & Rating (2)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
I was hoping it would be spinning very easily, but that’s definitely not the case
The designer has replied
0
Reply
Hi! I just updated the description to be more clear, I'm sorry it wasn't before. As long as the parts do move, it's as it should be. This was made more to fidget with than to spin freely and be loose.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld